Whirlpool Support

I believe that the GAS VALVE on this model hot water heater must be bad because it keeps shutting down. sometimes three/four times a day, even thou I have good gas pressure,vent\'s etc. I\'ve replaced the thermocouple several times already. I have been reading about a recall and wondered if this unit might be included in the recall.

I am draining the Whirlpool water heater, Model EE2H40RD045V and need to know the resistance of bothe heaters. Thanks

red light blinking 6 times for upper sensor failure. Can not figure out where this is located and if it needs replaced where to get it.

The drier thumps with every revolution. It has done this since the first week after installation (purchased July 1, 2010). If you watch the drier, the drum rotates in an elliptical pattern, like it has fallen off center at the front of the drum. How can this be fixed?

After replacing the bottom element, the unit will not run its self-diagnostic test, but keeps turning on and off every second, applying power only every other second. It is more than simply the green light blinking on and off. There is actually a cutting on and off of the 220V in cycles.